Cobra Electronics Marine Radio COBRAMARINE User Manual

3.0

Out of 1 Ratings

Owner's of the Cobra Electronics Marine Radio COBRAMARINE gave it a score of 3.0 out of 5. Here's how the scores stacked up:

  • Reliability

    3.0 out of 5

  • Durability

    3.0 out of 5

  • Maintenance

    3.0 out of 5

  • Performance

    3.0 out of 5

  • Ease of Use

    3.0 out of 5
of 45
 
Introduction
Nothing Comes Close to a Cobra
®
Product Features
37
36
English
Voice Transmission
Transmit Power Output
The radio transmits selectively at 1 or 25 watts of power.
Cobra suggests maintaining the low power setting for short-
range communications to avoid overpowering nearby stations
with the signal. Use the high power setting for long-range
communications or when no response is received from a
signal sent at 1 watt.
To Toggle Between the High and Low Power Modes:
Press the HI/LO Power button.
The LCD displays which mode is selected.
Some channels are restricted to be used at a maximum of 1
watt. The radio automatically sets the power to Low Power
mode when a restricted channel is selected.
While using the U.S.A. channel map, if, in an emergency, it is
necessary to increase the output power on Channel 13 and
Channel 67 for the signal to be heard, override the Low
Power mode by pressing and holding the HI/LO Power
button.
Transmit a Message
To Transmit a Message:
1. Check to see that the radio is set to a proper channel for
the type of message being sent.
2. Toggle to the low power setting by pressing the HI/LO
Power button.
3. With the microphone about 2 in. (51 mm) from your
mouth, press and hold the Talk button and speak into the
microphone. TX (Transmit) displays on the LCD display.
4. Release the Talk button when finished speaking. To hear
a response, the Talk button must be released.
Operating Your Radio
Voice Transmission
NOTE
If the Talk button is held down for five (5) minutes,
the radio automatically ceases transmitting to prevent
unwanted signal generation and a three (3)-beep error
tone sounds. As soon as the Talk button is released, it
can be pressed again to resume transmission.
Public Address
Use the Public Address (PA) mode of voice transmission to
communicate to other nearby vessels or people. This feature
requires a mounted and connected optional PA speaker.
To Broadcast on the PA Speaker:
1. Press the PA/ESC button on the front of the transceiver.
2. Press the Talk button on the microphone and speak into
the microphone.
NOTE
While in the PA mode:
■
When the Talk button is pressed; the output is
directed to the PA speaker and not transmitted as a
radio signal through the antenna.
■
Received radio messages are directed to the PA
speaker unless the Talk button is pressed.
3. To turn off PA, press PA/ESC button on the front of the
radio again or press the Function F1/F2 button on the
microphone to ESC.
Operating Your Radio
HI/LO Power Button
Standby High Power Mode
Standby Low Power Mode
Transmit High Power Mode
Transmit Low Power Mode
Talk Button
PA/ESC Button
MRF80BD_MANL_OPER:F75-Operation-8 12/9/10 10:35 AM Page 36

   Find Your Products By Category