Cobra Electronics Marine Radio COBRAMARINE User Manual

3.0

Out of 1 Ratings

Owner's of the Cobra Electronics Marine Radio COBRAMARINE gave it a score of 3.0 out of 5. Here's how the scores stacked up:

  • Reliability

    3.0 out of 5

  • Durability

    3.0 out of 5

  • Maintenance

    3.0 out of 5

  • Performance

    3.0 out of 5

  • Ease of Use

    3.0 out of 5
of 45
 
Nothing Comes Close to a Cobra
®
Mounting and
Powering the Radio
15
14
English
Included in this Package
Included in this Package
•
You should find all of the following items in the
package with your CobraMarine VHF radio:
NOTE
Cobra Accessory Harness CM 140-001 is an optional
wire harness that is
used to interface the MR F80 radio with the Cobra MC 600C Series
chartplotters.
Installation and Start-Up
Installation and Start-Up
Mounting and Powering the Radio
•
Before using your CobraMarine VHF radio, it must be installed on your vessel.
Installing Your Radio
Choose a location for your radio where it will be conveniently accessible with the
following factors in mind:
■
The leads to the battery and the antenna should be as short as possible.
■
The antenna must be mounted at least 3 ft (0,9 m) from the transceiver.
■
The radio and all speakers need to be far enough from any magnetic
compass to avoid deviation due to the speaker magnet.
■
There needs to be free air flow around the heat-sink fins on the back
of the transceiver.
Surface Mount
A Surface Mounting kit is included with your CobraMarine VHF radio to allow its
installation on almost any flat horizontal surface.
To Mount the Transceiver
on Almost any Flat Surface:
1. Use the mounting bracket as a template
to drill holes for the mounting screws.
2. Attach the mounting bracket to the
chosen surface with the mounting
bracket screws and washers.
3. Attach the transceiver to the mounting
bracket with the Tilt Lock knobs.
4. Tilt the transceiver to a convenient
angle and tighten the Tilt Lock knobs.
Surface Mounting Kit
Tilt Lock Knobs
Transceiver Transceiver Flush Mount Kit
16/9
Microphone
Transceiver Surface Mount Kit
Operating Instruction Manual
WARNING
This equipment is designed to generate a digital
maritime distress and safety signal to facilitate
search and rescue. To be effective as a safety
device, this equipment must be used only within
communication range of a shore-based VHF
marine channel 70 distress and safety watch
system. The range of the signal may vary out
under normal conditions should be approximately
20 nautical miles.
Warning Sticker
Power/Interface Cables
Mic Mounting Kit
MRF80BD_MANL_INSTALL:QXP-1058720374.qxp 12/9/10 10:34 AM Page 26

   Find Your Products By Category