Alesis Drums DM10 User Manual

0

Out of 0 Ratings

Owner's of the Alesis Drums DM10 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 52
 
2
GETTING STARTED
Please read the following instructions to set up your DM10 module for its first use!
RESETTING THE MODULE TO FACTORY DEFAULTS
If you ever need to return the module to its original default factory settings, press and hold the EXIT and
STORE buttons simultaneously while turning it on.
CHECK FOR UPDATES
Since the initial release of this module, we may have released new firmware or sound ROM files. To ensure
your DM10 module has the latest sounds and software features, we recommend checking the "Docs &
Downloads" tab of www.alesis.com/dm10prokit
for available updates. See the UPDATING THE MODULE
chapter for more information.
CALIBRATE YOUR HI-HAT PEDAL
The first time you connect a hi-hat pedal to the DM10 module, we
recommend calibrating it so the module can "read" the pedal's
movement optimally.
If you use the same hi-hat each session (even if you have disconnected
and reconnected it), then you shouldn't need to calibrate each time as long as you store your trigger settings
after calibrating (see STORING TRIGGER SETTINGS in the STORING & COPYING chapter for more
information). However, anytime you connect a different hi-hat from the previously connected one, you should
calibrate it.
To calibrate the hi-hat pedal:
1. Connect the hi-hat pedal to the module but do not press it down.
2. On the module, press EXT TRIG.
3. You will see a page with items including "Sensitvty" and "Function."
Use the CURSOR UP / DOWN buttons to highlight the "Input" field at
the top of the screen then use the VALUE UP / DOWN buttons to
select "HiHat."
4. Press CAL (F4).
5. With the hi-hat pedal completely raised ("open"), press CAL OPEN
(F1 or F2) and wait for a message saying the process is complete.
6. With the hi-hat pedal completely pressed ("closed"), press CAL
CLSED (F3 or F4) and wait for a message saying the process is complete.
7. Press EXIT to exit the calibration page (or press DRUM KIT to return to the main screen).
DEACTIVATE WRITE PROTECTION
Out of the box, the DM10 module is write-protected, so you will be unable
to save any changes you make to the Kits, Instruments, Sequences, etc.
To turn write protection off:
1. Press UTILITY.
2. Press SYS (F4).
3. Press O/S (F3).
4. Press MEM (F4).
5. Press VALUE DOWN or move the VALUE DIAL counterclockwise
until the "WriteProt" field says "OFF."
6. Press DRUM KIT to return to the main page.
Note: The module's HI-HAT
CONTROL TRIGGER INPUT
does not support keyboard-
style expression pedals.

   Find Your Products By Category