Humminbird Marine GPS System GPS User Manual

0

Out of 0 Ratings

Owner's of the Humminbird Marine GPS System GPS gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 92
 
82
Grayscale The useof varyingshades of gray to represent thestrength of the sonar signal
on the display. Traditionally, the strongest sonar signals are represented in black, and
progressively weaker signals are represented in progressively lighter shades of gray.
Noise The unintentional, external sound waves that interfere with the optimal operation
of sonar. Noise appears as random “dots“ on the display and is caused by a variety of
sources. ManyHumminbird®productshavea NoiseFiltermenusettingthatallowsthe user
to clear the screen of noise that is difficult to eliminate (also, see Troubleshooting).
Pixels The“pictureelements“, orsmall square blocks, thatmakeuptheimage ontheLCD.
Measured as a vertical by horizontal number (i.e. 640V x 320H), this key specification
typically indicates the quality of resolution. In fishfinders, the total resolution (vertical
multiplied byhorizontal) is often less importantthanthe“Vertical Pixel“resolution because
a greater number of vertical pixels provide finer resolution of targets detected by sonar.
Sonarinformationon thehorizontal axiscanvary greatly,dependingon boat speedand the
Chart Speed setting.
Power Output The amount of sound energy emitted into the water by the transducer’s
transmitter.PoweroutputismeasuredusingeitherRMS(RootMeanSquare)orP-T-P(Peak-
to-Peak) measurement systems. Either method is acceptable, but it is important when
comparing power outputs, to make sure that the same measurement system is being used
for both outputs, because P-T-P numbers are 8 times higher than RMS numbers. Greater
power output allows the sonar signal to penetrate through weeds and thermoclines, reach
deeper depths and operate more effectively in noisy environments, such as when the boat
is running at high speed.
Pulse Width (Pulse Length) The length of time that asonar sound burst istransmitted
into the water. Shorter pulse widths provide better target separation, but cannot travel to
great depths. Longer pulse widths provide better depth penetration, but result in poorer
target separation. Humminbird® varies pulse width based on depth to optimize both target
separation and depth performance. See Target Separation.
Second Return Describes the appearance of a second sonar return below the primary
sonar return (bottom contour) at exactly twice the true depth. The second return is caused
by the same sonar energy bouncing off the bottom once, rebounding to the water surface
and thentraveling back down to thebottomto be reflected again. Secondreturns are more
common in shallow water and over hard bottoms; it is possible to see a third sonar return
under some circumstances. The second return provides useful information to help
determine bottom hardness, as areas with harder bottoms will generally create a second
return.Thesecondreturncanbeusedasa guidetosetSensitivitywheninshallower water.
Glossary

   Find Your Products By Category