Cobra Electronics Marine Radio MARINE User Manual

0

Out of 0 Ratings

Owner's of the Cobra Electronics Marine Radio MARINE gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 42
 
Nothing Comes Close to a Cobra
®
External Devices
And Connections
23
22
English
External Devices
And Connections
External Devices And Connections
•
Your CobraMarine VHF radio is set up to connect auxiliary devices for navigation,
convenience, and added versatility. As is the case with the antenna, choosing these
devices is best done with the advice and guidance of a knowledgeable dealer.
Standard connectors are provided on the front and back of the transceiver.
Microphone/Speaker Attachment
Connect the Microphone/Speaker to the cord socket
located at the left side of the front of the transceiver.
To Connect The Microphone/Speaker Attachment:
1. Align the connector and push it firmly into the socket.
2. Tighten the captive nut to hold the connector in place.
3. Slide the waterproof sleeve over the nut until it seats
in the recess around the socket.
External Speaker (Not Included)
An External Speaker can provide greater volume to
hear messages than the speaker incorporated in the
CobraMarine microphone/speaker.
To Install An External Speaker:
1. Connect the speaker lead to the standard jack
on the back of the transceiver.
Public Address Speaker (Hailer)
(Not Included)
At times, it may be handy to hail other boats or give
instructions to line handlers on the dock. Your CobraMarine
VHF radio can be switched to operate in the Public Address
mode through an attached PA speaker.
To Install A Public Address Speaker:
1. Connect the PA speaker lead to the standard
jack on the back of the transceiver.
Global Positioning System (GPS) Device (Not Included)
Cobra
®
strongly recommends that you obtain and connect a GPS device to
your CobraMarine VHF radio. By having a GPS connected, your position will
be continuously indicated on the LCD and, most importantly, it will be included
automatically in any DSC distress message you may need to send. That will
take the “search” out of “search and rescue.”
To Install A GPS Device:
1. Install the GPS device in a convenient location
according to its manufacturer’s directions.
2. Bond the NMEA out negative wire to the black
wire of the GPS interface cable.
3. Bond the NMEA out positive wire to the red
wire of the GPS interface cable.
NOTE
When bonding the wires, make sure connections
are secure and properly insulated.
4. Connect the new combination cable to the GPS
device and to the back of the transceiver.
NOTE
Satellite acquisition time is dependent on the
GPS device.
Installation And Start-Up Installation And Start-Up
GPS Connection
Microphone/Speaker
Cord Connection Socket
External Speaker
and PA Jack
External Speaker
and PA Jack
F75D_MANL_INSTALL:F75D_MANL_INSTALL.qxd 12/13/10 3:51 PM Page 32

   Find Your Products By Category