Char-Broil Charcoal Grill THE BIG EASY User Manual

0

Out of 0 Ratings

Owner's of the Char-Broil Charcoal Grill THE BIG EASY gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
ASSEMBLY
2
1
Tools required for assembly:
Phillips Screwdriver (Not Supplied); Small Adjustable Wrench (Not Supplied)
•
Carefully turn the unit upside down.
Slide Heat Shield into place over the exposed burner tube.
•
Align hole in
Heat Shield
with end of
Burner Tube
Heat Shield in Position
•
While holding the Heat Shield in place, slide the Control Panel Assembly into place, taking care to ensure that
the valve engages the burner tube. shown Figure A
•
Install two #10x3/8" self-tap screws through the right side of the control panel. Leave screws loose.
Make sure valve is inside burner tube. Align the heat shield as shown Figure B.
•
Hold Heat Shield in place while attaching Control Panel
NOTE:
Install these
NOTE:
Ensure that the valve engages the burner tube
Ignitor Wire
Qty: 4
#10x3/8"
Self-Tap Screw
Fig. A
Proper Valve to Burner Tube installation
(veiw from underneath control panel)
Page 13
Burner
Tube
Valve
End
Ignitor Wire
Screw hole
for leg - used
later.
screws first!
Fig. B
Secure control panel using the two remaining #10x3/8” self-tap screws. Tighten all four screws.
Screw hole
for leg - used
later.
Heat shield
Control
Panel
Carefully insert valve end into burner tube making sure valve is centered with burner tube,
after aligned correctly, loosely secure with two self-tap screws on RH side of control panel.

   Find Your Products By Category