Linksys Network Card WRE54G User Manual

0

Out of 0 Ratings

Owner's of the Linksys Network Card WRE54G gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 41
 
15
Chapter 5: Configuring the Wireless-G Range Expander
The Setup Tab
Wireless-G Range Expander
The Setup Tab
Basic Setup
The first screen that appears displays the Basic Setup screen. This allows you to change the Range Expander's
general settings. Change these settings as described here and click Save Settings to apply your changes or
Cancel Changes to cancel your changes. If you require online help, click Help.
• Firmware. This will display the Range Expander's current firmware version. Firmware can be upgraded from
the Help tab.
• Name. You may assign any name to the Range Expander. Unique, memorable names are helpful, especially if
you are employing multiple Range Expanders on the same network. Verify this is the name you wish to use
and click Save Settings to set it.
Wireless
The selections under this heading allow you to configure the Range Expander’s connection to your wireless
network.
• IP Address. The IP address must be unique to your network. We suggest you use the default IP address of
192.168.1.240.
• Subnet Mask. The Subnet Mask must be the same as that set on your wireless network.
• Gateway. If you have assigned a static IP address to the access point, then enter the IP address of your
network’s Gateway, such as a router, in the Gateway field. If your network does not have a Gateway, then
leave this field blank.
• Mode. Select Mixed and both Wireless-G and Wireless-B computers will be allowed on the network, but the
speed will be reduced. Select G-Only for maximum speed with Wireless-G products only. The final selection,
B-Only, allows only Wireless-B products on the network.
• SSID. The SSID is the name shared among all points in a wireless network. The SSID must be identical for all
points in the wireless network. It is case-sensitive and must not exceed 32 alphanumeric characters, which
may be any keyboard character. Make sure this setting is the same for all points in your wireless network. For
added security, you should change the SSID from the default name, linksys, to a unique name.
• SSID Broadcast. Allows the SSID to be broadcast on your network. You may want to enable this function
while configuring your network, but make sure that you disable it when you are finished. With this enabled,
Figure 6-2: Setup Tab - Basic Setup
firmware: the programming code that runs a
networking device
static ip address: a fixed address assigned to a
computer or device that is connected to a network
subnet mask: an address code that determines
the size of the network.

   Find Your Products By Category