Humminbird Marine GPS System 4087301 User Manual

4.1

Out of 8 Ratings

Owner's of the Humminbird Marine GPS System 4087301 gave it a score of 4.1 out of 5. Here's how the scores stacked up:

  • Reliability

    4.14 out of 5

  • Durability

    4.29 out of 5

  • Maintenance

    4.0 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    4.14 out of 5
of 75
 
the problem, inspect the transducer cable from end to end for breaks, kinks, or cuts in
theoutercasingofthecable.Ifthetransducerisconnectedtotheunitthroughaswitch,
temporarily connect it directly to the unit and try again. If none of these actions
identifies an obvious problem, the transducer itself may be at fault. Be sure to include
the transducer if returning the unit for repair.
4. When in very shallow water, I get gaps in the bottom reading and inconsistent
digital depth indication.
ThePiranhaMAXwillworkreliablyin water3 feet(90cm)ordeeper.Rememberthatthe
depth is measured from the transducer, not from the surface of the water.
5. The unit comes on before I press the POWER-MENU key, and won’t turn off.
Check the transducer cable — if the outer jacket of the cable has been cut and the
cable is in contact with bare metal, you will need to repair the cut with electrical tape.
If there is no problem with the cable, disconnect the transducer from the unit and see
if the problem is corrected, to confirm the source of the problem.
6. I get gaps in the reading at high speeds.
Your transducer needs adjusting. If the transducer is transom-mounted, there are two
adjustments available to you: height, and running angle. Make small adjustments and
runtheboatat highspeeds to determinethe effect. Itmay take several tries to optimize
high-speed operation. This can also be a result of air or turbulence in the transducer
location caused by rivets, ribs, etc.
7. My unit loses power at high speeds.
Your PiranhaMAXhas over-voltage protection that turns theunitoff when input voltage
exceeds 20 VDC.Someoutboard motorsdo not effectively regulate the power output of
the engine’s alternator and can produce voltage in excess of 20 Volts when running at
high RPMs.
8. The display begins to fade out. Images are not as sharp as normal.
Check the input voltage. The PiranhaMAX will not operate on input voltages below 10
VDC.
9. The displayshows many black dots athighspeeds andhighsensitivity settings.
You are seeing noise or interference caused by one of several sources. Noise can be
caused by electronic devices. Turn off any nearby electronics and see if the problem
goes away. Noise can also be caused by the engine. If engine noise is causing the
interference,the problem will intensifyat higher RPMs. Increasetheengine speed with
theboatstationarytoisolatethiscause.Propellercavitationcanalsoappearasnoiseon
the display. If the transducer is mounted too close to the propeller, the turbulence
generatedcaninterferewiththesonarsignal.Makesurethatthetransducerismounted
at least 15" (380 mm) from the propeller.
65
Troubleshooting

   Find Your Products By Category