0

Out of 0 Ratings

Owner's of the Humminbird Marine GPS System 4086301 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 75
 
26
6. Fit the transducer jumper cable connector down into the jumper cable
well and snap it into place. Insert the two #6-32 x 1/4" screws included
to secure the transducer jumper connector and tighten using a Phillips
screwdriver. Hand tighten only!
7. Secure all cables to the base, using the included zip ties, at the mount
points shown in the illustration (see the illustration Tying Down the
Cables).
8. Turn the base right side up and pull up gently on the battery tie-down
straps to remove the slack.
NOTE: You will need to perform more assembly procedures, as well as charge
the battery for 8 hours, before you install the battery into the portable case. See
Charge and Install the Battery for more information.
Tying Downthe Cables
Transducer
Jumper Cable
Zip Tie
Mounting
Point
Power Cable
Figure37
PiranhaMAX Portable Case Assembly