Clarion GPS Receiver NP401 User Manual

0

Out of 0 Ratings

Owner's of the Clarion GPS Receiver NP401 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 81
 
English
Owner’s
Manual
NP401 79
4. Cautions on Installation
1. Prepare all articles necessary for installing the source unit before starting.
2. If you have to do any work on the car body, such as drilling holes, consult your car dealer before hand.
3. Use the enclosed screws for installation. Using other screws can cause damage. (Figure 1)
Chassis Chassis
Damage
Max. 8 mm (M5 screw)
Max. 5mm (M2.6 screw)
Figure 1
5. Cautions on Wiring
1. Be sure to turn the power off before wiring.
2. Beparticularlycarefulwhereyouroutethewires.Keepthemwellawayfromtheengine,andexhaustpipe,etc.Heatmay
damage the wires.
3. If the fuse should blow, check to see if the wiring is correct.
If a fuse is blown, replace it with a new one of the same amperage rating as the original.
6. Wire Connections
Note:
•
Before installing, be sure to disconnect the negative cable of the car battery.
3. General Cautions
1. Do not open the case. There are no user- serviceable parts inside. If you drop anything into the unit during installation,
consult your dealer or an authorized Clarion service center.
2. Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzine, or alcohol etc. For tough dirt, apply a
little cold or warm water to a soft cloth and wipe off the dirt gently.
NP401 OM_100920_EN.indd 79 2011-1-6 16:11:04

   Find Your Products By Category