CHIEF Personal Lift CHIEF Personal Lift User Manual

0

Out of 0 Ratings

Owner's of the CHIEF Personal Lift CHIEF Personal Lift gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 8
 
CMA395 Installation Instructions
4
ASSEMBLY AND INSTALLATION
NOTE: The CMA395 ceiling plate is designed for ease of
installation with any height of ceiling with 2" x 4" or
larger wood joists. By using any length of standard NPT
1 1/2" NPT following ANSI/ASME B1.20.1 (Schedule
40, 0.154" minimum thickness aluminum - ASTM
B221) threaded extension column with both ends
threaded (not included), the height capabilities may be
extended as needed.
1. Loosen two angle adjustment screws to allow for
adjustment of pipe coupler angle. (See Figure 1)
2. Adjust pipe coupler to desired angle. (See Figure 1)
3. Tighten two angle adjustment screws. (See Figure 1)
4. Install 1-1/2" NPT following ANSI/ASME B1.20.1 (Schedule
40, 0.154" minimum thickness aluminum - ASTM B221)
threaded extension column (not included) into CMA395 until
tight, with a minimum of four threads engaged. (See Figure 1)
5. Use set screw (C) to secure extension column to CMA395
coupler. (See Figure 1)
Figure 1
6. Determing mounting location on ceiling.
7. Use CMA395 (A) plate to mark hole locations for ceiling
installation. (See Figure 2)
Figure 2
8. Drill two 1/4" pilot holes into wood joists at marked locations.
9. Install CMA395 (A) to ceiling using two 3/8 x 2 1/2" lag bolts
(not included) and two 3/8" washers (not included). (See
Figure 3)
IMPORTANT ! : The CMA395 must be attached to
ceiling using two 3/8 x 2 1/2" lag bolts and 3/8" washers
(not included).
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
Figure 3
extension pipe
5
(C) x 1
2
1
3
(not included)
4
6
x 2
(A)
wood stud surface
(A)
lag bolts (not included)
3/8 x 2 1/2"
3/8" washers
(not included)

   Find Your Products By Category