Blue Rhino Patio Heater Endless Summer User Manual

1.4

Out of 1 Ratings

Owner's of the Blue Rhino Patio Heater Endless Summer gave it a score of 1.4 out of 5. Here's how the scores stacked up:

  • Reliability

    1.0 out of 5

  • Durability

    1.0 out of 5

  • Maintenance

    1.0 out of 5

  • Performance

    1.0 out of 5

  • Ease of Use

    3.0 out of 5
of 12
 
®
Outdoor Patio Heater Model No. GWU9209SP Contact 1.800.762.1142 for assistance. Do not return to place of purchase.
Specifications
Certifications:
CSA International Requirement 5.90
Canadian National Standard CAN1-2.23-M82
Rating:
Maximum 40,000 BTU/hr. input
Heat Range:
Up to 20 foot diameter
Fuel:
Liquid Propane Gas (LP)
Tank Size:
Nominal 20 lb / 5 Gallon
Inlet gas supply pressure:
Maximum – 150 PSI
Minimum – 5 PSI
Manifold Pressure:
11.00 in. W.C.
Engine:
IPP E1
Safety Features:
100% Burner shut-off
Tilt Switch
Manufacturer:
Blue Rhino Global Sourcing, Inc
Made In:
China
Troubleshooting
If the problem is: And this condition exists: Then do this
Pilot won’t light
Note: Heater operates at reduced efficiency below 40ºF (5ºC).
Tank valve is closed Open valve
Blockage in orifice or pilot tube Clean or replace orifice or pilot tube
Air in gas line Open gas line and bleed it (pressing control knob in) for not more
than 1 - 2 minutes or until you smell gas
Low gas pressure with tank valve fully open Turn tank valve “OFF” and replace tank
Igniter fails Use match to light pilot; obtain new igniter and replace
Pilot won’t stay lit
Dirt built up around pilot Clean dirt from around pilot
Connection between gas valve and pilot assembly is loose Tighten connection and perform leak check
Thermocouple is not operating correctly Replace thermocouple
Burner won’t light
Gas pressure is low Turn tank valve “OFF” and replace tank
Blockage in orifice Clear blockage
Control knob is not in “ON” position Turn control knob to “ON”
Burner flame is low
Gas pressure is low Turn tank valve “OFF” and replace tan
Outdoor temperature is less than 40ºF and tank is less than 1/4
full
Use a full tank
Supply hose is bent or kinked Straighten hose
Control knob fully “ON” Check burner and orifices for blockage
Emitter glows uneven
Note: Bottom 1” of emitter normally does NOT glow.
Gas pressure is low Turn tank valvue “OFF” and replace tank
Base is not on a level surface Place heater on a level surface
Heater is level Clean burner
Carbon build-up
Dirt or film on reflector and emitter Clean reflector and emitter
Thick black smoke
Blockage in burner Remove blockage and clean burner inside and outside
For more assistance please visit us online at www.bluerhino.com or call 1.800.762.1142 for immediate assistance.

   Find Your Products By Category