Black & Decker Trimmer Black & Decker Trimmer / Edger User Manual

2.0

Out of 1 Ratings

Owner's of the Black & Decker Trimmer Black & Decker Trimmer / Edger gave it a score of 2.0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    2.0 out of 5

  • Maintenance

    2.0 out of 5

  • Performance

    3.0 out of 5

  • Ease of Use

    3.0 out of 5
of 44
 
12
TOOL RUNS SLOWLY
• Check that the spool housing can rotate freely. Carefully clean it if
necessary.
• Check that the cutting line does not protrude more than
approximately 5-3/8 inches (136mm) from the spool. If it does, cut
it off so that it just reaches the line trimming blade.
AUTOMATIC LINE FEED DOES NOT WORK
• Keep the tabs depressed and remove the spool from the spool
housing in the trimmer head.
• Pull the cutting line until it protrudes approximately 5-3/8 inches
(136mm) from the spool. If insufficient cutting line is left on the
spool, install a new spool of cutting line.
• Ensure that the line is not crisscrossed on the spool as detailed
in figure 18. If it is, unwind the cutting line, then wind it back on
the spool neatly so that the lines do not cross.
• Align the tabs on the spool cap with the cut outs in the housing.
• Push the spool onto the housing until it snaps securely into place.
• If the cutting line protrudes beyond the trimming blade, cut it off
so that it just reaches the blade. If the automatic line feed still
does not work or the spool is jammed, try the following
suggestions:
• Carefully clean the spool and housing.
• Remove the spool and check if the lever in the spool housing
can move freely.
• Remove the spool and unwind the cutting line, then wind it on
neatly again. Replace the spool into the housing.
All Black & Decker Service Centers are staffed with trained
personnel to provide customers with efficient and reliable power tool
service. Whether you need technical advice, repair, or genuine
factory replacement parts, contact the Black & Decker location
nearest you. To find your local service location, refer to the yellow
page directory under "Tools—Electric" or call: 1-800-544-6986 or
visit www.blackanddecker.com
Black & Decker (U.S.) Inc. warrants this product for two years
against any defects in material or workmanship. The defective
product will be replaced or repaired at no charge in either of two
ways.
The first is to return the product to the retailer from whom it was
purchased (provided that the store is a participating retailer).
Returns should be made within the time period of the retailerʼs
policy for exchanges (usually 30 to 90 days after the sale). Proof of
purchase may be required. Please check with the retailer for their
specific return policy regarding returns that are beyond the time set
for exchanges.
The second option is to take or send the product (prepaid) to a
Black & Decker owned or authorized Service Center for repair or
replacement at our option. Proof of purchase may be required.
Black & Decker owned and authorized Service Centers are listed
under "Tools-Electric" in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives
you specific legal rights and you may have other rights which vary
from state to state or province to province. Should you have any
questions, contact the manager of your nearest Black & Decker
Service Center. This product is not intended for commercial use.
SERVICE INFORMATION
FULL TWO-YEAR HOME USE WARRANTY
TROUBLESHOOTING

   Find Your Products By Category