Cobra Electronics Marine Radio COBRA MARINE User Manual

1.0

Out of 1 Ratings

Owner's of the Cobra Electronics Marine Radio COBRA MARINE gave it a score of 1.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 40
 
Nothing Comes Close to a Cobra
®
Mounting And
Powering The Radio
17
Installation And Start-Up
Mounting And Powering The Radio
•
Before using your CobraMarine VHF radio, it must be installed on your vessel.
Installing Your Radio
Choose a location for your radio where it will be conveniently accessible with the
following factors in mind:
■
The leads to the battery and the antenna are best kept as short as possible.
■
The antenna must be mounted at least 3 feet (0.9m) from the transceiver.
■
The radio and all speakers need to be far enough from any magnetic
compass to avoid deviation due to the speaker magnet.
■
There needs to be free air flow around the heat-sink fins on the back
of the transceiver.
Surface Mount
A Surface Mounting kit is included with your CobraMarine VHF radio to allow its
installation on almost any flat surface.
To Mount The Transceiver
On Almost Any Flat Surface:
1. Use the mount
ing bracket
as
a template to drill holes
for the mounting screws.
2. Attach the mounting bracket
to the chosen surface with the
mounting bracket screws and
washers.
3. Attach the transceiver to
the mounting bracket with
the tilt lock knobs.
4. Tilt the transceiver to
a convenient angle and
tighten the tilt lock knobs.
16
English
Mounting And
Powering The Radio
Installation And Start-Up
Microphone Bracket
To Install The Microphone Bracket:
Install the microphone bracket on a vertical surface near the
transceiver using the supplied stainless steel screws.
Flush Mount Kit (Not Included)
A Flush Mounting kit is available as an optional accessory
for your CobraMarine VHF radio to allow its installation in
almost any flat surface. See page 15 for ordering
information.
To Mount The Transceiver
Flush In Almost Any Flat Surface:
1. Use
the supplied template to mark and cut an opening
in the flat surface. See page 75 for template.
NOTICE
Before cutting, be sure the area behind the flat
surface is clear of any instruments or wires that
might be damaged in the process.
2. Insert the transceiver into the opening.
3. Attach the mounting brackets to
the sides of the transceiver with
the adjusting scre
w flanges facing
the
back of the flat surface.
4. Tighten the adjusting screws against
the back of the flat surface until the
flange on the front of the transceiver
is tight against the flat surface. Do
not over-tighten.
Surface Mounting Kit
Tilt Lock Knobs
Use Supplied Template
See page 75
for template.
Insert Transceiver
Adjust Screws
Microphone Bracket
Attach Mounting Brackets
F45D_Install_Eng:8186-F55_Install-Eng 11/23/10 10:48 AM Page 26

   Find Your Products By Category