0

Out of 0 Ratings

Owner's of the D-Link Marine Radio D-Link Unified Access Point Administrators gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 128
 
Unied Access Point Administrator’s Guide
Unied Access Point Administrator’s Guide
Page 23
March 2012
Section 3 - Viewing Access Point Status
Modify Wireless Settings page.
For information about conguring these settings, see “Wireless Settings” on page 37 and “Modifying Radio Settings”
on page 40.
Viewing Events
The Events page shows real-time system events on the AP such as wireless clients associating with the AP and being
authenticated.
To view system events, click the Events tab.
Figure 6 - Viewing Events
From the Events page, you can perform the following tasks:
•) View the most recent, high-level events generated by this AP.
•) Enable and congure Persistent logging to write system event logs to non-volatile memory so that the events
are not erased when the system reboots.
•) Set a Severity Level to determine what category of log messages are displayed.
•) Set Depth to determine how many log messages are displayed in the Event log.
•) Enable a remote log relay host to capture all system events and errors in a Kernel Log.
Note: The AP acquires its date and time information using the network time protocol (NTP). This
data is reported in UTC format (also known as Greenwich Mean Time). You need to convert the
reported time to your local time.
Conguring Persistent Logging Options
If the system unexpectedly reboots, log messages can be useful to diagnose the cause. However, log messages are
erased when the system reboots unless you enable persistent logging.
Caution! Enabling persistent logging can wear out the ash (non-volatile) memory and degrade
network performance. You should only enable persistent logging to debug a problem. Make sure
you disable persistent logging after you nish debugging the problem.
To congure persistent logging on the Events page, set the persistence, severity, and depth options as described in
the following table, and then click Apply.