0

Out of 0 Ratings

Owner's of the Cobra Electronics Marine Radio MRHH350FLT gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 34
 
VHF Marine Radio Protocols
17
Nothing Comes Close to a Cobra
®
Setup Mode Programming
Setup Mode Programming
The following series of procedures is designed to allow you
to set the programmable features of your radio. Correctly
following these steps results in a minimal amount of radio
setup programming time.
During setup programming, the matrix display will show text
describing the programming action you are now performing.
NOTE
When in the Setup mode, if you stop programming for
longer than 15 seconds,
your entry will be saved and
the radio will go back to the Marine Standby mode.
When you return to Setup mode and continue
programming you will see the last “value” displayed.
While in the Setup mode, you will not receive any
signal reception except when setting squelch.
Programming these features will allow you to customize
certain features of this radio to enhance your “On-Water”
radio use.
Start from Marine Standby mode to begin Marine (VHF)
Setup programming. STANDBY will be displayed on the
matrix. Press and hold the Call/Enter/Setup button for two
(2) seconds to enter the programming mode.
The mode programming follows this sequence:
Squelch Level Set
UIC Channel Map
Tone Alert On/Off
Call Tone Select
Roger Beep On/Off
Key Tone On/Off
Marine (VHF) Mode Programming
VHF Marine Radio Protocols
16
English
Getting Started
High/Medium/Low (H-M-L) Power Button
Your radio can transmit selectively at 1, 3 or 6 watts of
power. Cobra suggests you maintain the low power setting
for short-range communications. You will conserve battery
life and avoid overpowering nearby stations with a low power
setting signal. Use the high power setting for long-range
communications or when you do not receive a response to
a signal sent at 1 watt.
To Toggle Between H-M-L Power Modes:
Press the H-M-L Power button. The LCD will show
which mode is in effect. Some channels are restricted
for a maximum use of 1 watt. Your radio will
automatically set the power to Low Power mode
when you select those channels.
NOTE
Some channels, frequency bands and countries of use
might not be able to operate in High Power mode.
Call/Enter/Setup Button
NOTE
A few channels are Receive only and will not transmit
in these channels.
The Call/Enter/Setup button has multiple functions. It is
generally used in the following ways:
Press and release to transmit your unique Call Tone signal
to another radio.
Press and hold to enter any Setup menu.
Functions as an Enter button when making a selection
in any Setup menu.
WX
H M L
SC
EM
H-M-L Power Button
MEM
ENT SETUP
CALL
Call/Enter/Setup Button
Operating Your Radio
Operating Your Radio
MEMSAMEATIS VOX
LO MEDHI
VHF
T
R
A
B
GMRS
X
CIU
Marine Standby Mode
350_VHF_Body_v8_MRHH330_ENG_Body 3/26/13 11:45 AM Page 16